Sntp Client Enable - Cisco SPS2024 Reference Manual

Clock Commands

sntp client enable

sntp client enable
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The sntp client enable Global Configuration mode command enables the Simple
Network Time Protocol (SNTP) Broadcast and Anycast client on an interface. Use
the no form of this command to disable the SNTP client.
Syntax
sntp client enable { vlan
number]
no sntp client enable {vlan
number]
Parameters
•
vlan-id — VLAN number
•
interface
— Valid Ethernet port
•
port-channel-number
Default Configuration
The SNTP Anycast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use the sntp broadcast client enable Global Configuration mode command to
enable Broadcast clients globally.
Use the sntp anycast client enable Global Configuration mode command to enable
Anycast clients globally.
vlan-id
} [ethernet interface| port-channel port-channel-
vlan-id } [ethernet interface | port-channel port-channel-
— Valid port-channel number
6
112