RADIUS Commands
radius-server host
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The radius-server host Global Configuration mode command specifies a RADIUS
server host. Use the no form of this command to delete the specified RADIUS host.
Syntax
ip-address
radius-server host {
acct-port-number
port
key-string
[key
] [source
no radius-server host {
Parameters
•
ip-address
— IP address of the RADIUS server host.
•
hostname
— Hostname of the RADIUS server host. (Range: 1-158
characters)
•
auth-port-number —
not used for authentication if the port number is set to 0. (Range: 0-65535)
•
acct-port-number
used for accountings if set to 0.
•
timeout
— Specifies the timeout value in seconds. (Range: 1-30)
•
retries
— Specifies the retransmit value. (Range: 1-10)
•
deadtime
— Length of time in minutes during which a RADIUS server is
skipped over by transaction requests. (Range: 0-2000)
•
key-string
— Specifies the authentication and encryption key for all
RADIUS communications between the device and the RADIUS server. This
hostname
|
} [auth-port
timeout
] [timeout
] [retransmit
source
priority
] [priority
ip-address
hostname
|
Port number for authentication requests. The host is
— Port number for accounting requests. The host is not
24
auth-port-number
retries
] [deadtime
type
] [usage
]
}
] [acct-
deadtime
]
306