Control Disable - Cisco XR 1200 series Command Reference Manual

control disable

control disable
To disable the control packets, use the control disable command in the appropriate configuration mode. To
use the control packets again, use the no form of this command.
control disable
no control disable
Syntax Description
This command has no keywords or arguments.
Command Default
Control packets are enabled by default.
Command Modes
IP SLA UDP echo configuration
IP SLA UDP jitter configuration
Command History
Release
Release 3.3.0
Usage Guidelines
When you configure the control disable command on the agent side, you need to configure a permanent port
on the responder side or the operation returns a timeout error. If you configure the control disable command,
a permanent port of the IP SLA Responder or some other functionality, such as the UDP echo server, is
required on the remote device.
The control disable command is valid for operations that require a responder.
The IP SLA control protocol is disabled, which is used to send a control message to the IP SLA Responder
prior to sending an operation packet. By default, IP SLA control messages are sent to the destination device
to establish a connection with the IP SLA Responder.
Task ID
Task ID
monitor
Examples The following example shows how to use the control disable command in IP SLA UDP jitter configuration
mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
126
IP Service Level Agreement Commands
Modification
This command was introduced.
Operations
read, write
OL-24735-01