Spark Arrester - BRP BOMBARDIER DS250 2006 Shop Manual

vmr2006-069-005_a
Inspection
Check part for cracks, rust or any other default.
Replace damaged part as necessary.
Installation
Installation is the reverse procedure of removal.
However, pay attention to the following.
Loosely install pipe and muffler before tightening
all parts. Torque exhaust pipe nuts first.

SPARK ARRESTER

All Models except Europe
The spark arrester must be periodically purged of
accumulated carbon.
WARNING
Never perform this operation immediately af-
ter the engine has been run because exhaust
system is very hot. Wear eye protection and
gloves. Respect all applicable laws and reg-
ulations.
Removal
Remove the spark arrester from the muffler.
vmr2006-069
Subsection 04 (EXHAUST SYSTEM)
vmo2006-014-042_a
1. Remove muffler end
2. Muffler
vmo2006-013-006_a
1. Spark arrester
Cleaning
Remove carbon deposits from the spark arrester
using a brush.
NOTE: Use a soft brush and be careful to avoid
damaging spark arrester.
Installation
Installation is the reverse procedure of removal.
Section 03 ENGINE
39