BRP BOMBARDIER DS250 2006 Shop Manual page 170

SWITCH
WIRE COLOR
POSITION
LO beam WHITE
HI beam BLUE
If voltage is good, replace headlamp bulb.
If there is no voltage, recheck by measuring volt-
age as follows.
vmr2006-081-004_b
ALL MODELS EXCEPT EUROPE
vmr2006-081-005_b
EUROPEAN MODELS
SWITCH
WIRE COLOR
POSITION
LO beam WHITE
HI beam BLUE
If voltage is good, check headlamp ground wire.
If voltage is not good, continue testing.
vmr2006-081
VOLTAGE
Battery voltage
GREEN
VOLTAGE
Battery
Battery voltage
ground
Section 05 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS AND ACCESSORIES)
LO Beam Relay
Disconnect LO beam relay connector.
vmr2006-081-003_a
Using a jumper wire, connect wires as follows.
vmr2006-081-006_a
RELAY CONNECTOR WIRES
RED/WHITE
Battery voltage should appear to headlamp termi-
nals. If so, replace relay. Otherwise, check wire
between relay and headlamp and also wire from
battery to relay.
Reconnect relay connector and retry headlamps.
If they do not work, continue testing.
HI Beam Relay
Disconnect HI beam relay connector.
WHITE
151