BRP BOMBARDIER DS250 2006 Shop Manual page 183

Section 05 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS AND ACCESSORIES)
vmr2006-081-020_e
If so, check module ground wire .
Otherwise, check supply wire from battery to
module.
Reinstall removed parts.
Hi Beam Lamp (European models)
First ensure hi beam headlamps work. If so, con-
tinue testing. Otherwise, refer to HEADLAMP.
Use a multimeter and set it to Vdc.
Measure voltage at lamp socket as follows.
vmr2006-081-019_c
HI BEAM LAMP SOCKET
WIRES
Battery
BLUE
ground
If battery voltage is present, check socket ground
wire.
164
VOLTAGE
Battery voltage
If there is no voltage, check supply wire of socket.
Reinstall removed parts.
Turn signal Lamp (European models)
Use a multimeter and set it to Vdc.
Measure voltage at lamp socket as follows.
vmr2006-081-019_c
TURN TURN SIGNAL LIGHT SOCKET
SIGNAL
SWITCH
WIRES
POSITION
Left
ORANGE
LIGHT
Right
BLUE
If battery voltage is present, check socket ground
wire.
If there is no voltage, check supply wire of socket
from hazard control module. If it is good, replace
hazard module.
Reinstall removed parts.
Hazard Lamp (European models)
Refer to TURN SIGNAL LAMP above. The same
tests apply. The difference is that both lamps blink
simultaneously.
Lamp Replacement
Remove steering cover. Refer to STEERING AND
FRONT SUSPENSION.
Pull lamp out.
Install new lamp.
Reinstall lamp.
Validate lamp works.
VOLTAGE
Battery Pulsating
ground battery voltage
vmr2006-081