Flywheel - BRP BOMBARDIER DS250 2006 Shop Manual

vmr2006-072-005_a
Removal
Remove magneto cover.
NOTE: It is not necessary to remove stator to re-
move bearing.
Always heat bearing bore up to 100°C (212°F) be-
fore removing its bearing. Use a heat gun.
WARNING
Clean oil, outside and inside, from cover be-
fore heating. Oil is inflammable.
CAUTION: Always support cover properly to
remove bearing. Damage may occur if this
procedure is not performed correctly.
Remove snap ring.
vmr2006-072-005_a
To remove bearing, use a blind hole bearing puller
with a hammer puller.
vmr2006-072
Subsection 07 (MAGNETO AND STARTER DRIVE)
Installation
Use an appropriate pusher to install magneto cov-
er bearing.
CAUTION: Always support cover properly
when installing bearing.
Never use a hammer to install bearing. Use a
press only.
Always heat cover housing up to 100°C (212°F)
before installing bearing. Use a heat gun.
Clean oil, outside and inside, from housing
before heating. Oil is inflammable.
Place new bearing in freezer for 10 minutes before
installation.
Push against outer race to install bearing in its
bore.

FLYWHEEL

Removal
Remove magneto cover.
Hold flywheel with an appropriate pulley retainer.
NOTE: If you are unable to retain flywheel, re-
move CVT cover and block drive pulley with the
pulley holder. Refer to CONTINUOUSLY VARI-
ABLE TRANSMISSION (CVT) SYSTEM.
Remove flywheel nut.
vmr2006-072-008
Section 03 ENGINE
WARNING
65