Master Cylinder Of Rear Brake Pedal; Front Brake Pressure Control Valve - BRP BOMBARDIER DS250 2006 Shop Manual

Section 09 BRAKING SYSTEM
Subsection 01 (FRONT AND REAR BRAKES)
Apply suspension synthetic grease (P/N 293 550
033) on shaft before installing rear brake pedal.
MASTER CYLINDER OF REAR
BRAKE PEDAL
Removal
Drain rear brake pedal circuit. Refer to BRAKE
FLUID REPLACEMENT in this section.
Remove E-clip holding yoke to the end of rear
brake pedal.
vmr2006-085-024_a
Then, remove pin to separate yoke and rear brake
pedal.
vmr2006-085-025_a
Unplug brake fluid reservoir hose from master
cylinder.
Remove Banjo fitting that attach brake hose to the
top of master cylinder. Discard sealing washers
and catch spilled fluid with a rag.
Remove bolts securing master cylinder to frame.
232
vmr2006-085-028_a
1. Brake fluid reservoir hose
2. Banjo fitting
3. Brake hose
4. Master cylinder bolts
Installation
For installation, reverse the removal procedure.
Refill and bleed the rear brake pedal circuit.
WARNING
Bleed rear brake pedal circuit before riding
vehicle.
FRONT BRAKE PRESSURE
CONTROL VALVE
Removal
Loosen wheel nuts, raise vehicle and support it
securely then remove wheel on right side.
Drain front brake. Refer to BRAKE FLUID RE-
PLACEMENT.
Disconnect the four (4) brake hoses. Discard seal-
ing washers and catch spilled fluid with a rag.
Unscrew bolts securing pressure control valve to
frame.
vmr2006-085