BRP BOMBARDIER DS250 2006 Shop Manual page 92

mmr2006-073-006_a
TDC MARK BESIDES THE "T" ALIGNED
Check if marks are aligned on camshaft gear as
shown. Otherwise, continue turning drive pulley
until crankshaft and camshaft marks are properly
positioned.
mmr2006-073-008_a
Remove camshaft gear bolts. Detach gear from
chain.
vmr2006-073
Subsection 08 (CYLINDER HEAD)
mmr2006-073-009_a
NOTE: Attach timing chain to prevent it from
falling.
Remove camshaft locking plate.
Screw in a M5 x 0.8 x 75 screw in rocker arm shaft
end then pull it out. Remove both shafts.
NOTE: The throttle idle stop screw can be used.
mmr2006-073-010_a
Remove camshaft. Use a suitable puller or care-
fully pry out with a screwdriver.
Section 03 ENGINE
73