BRP BOMBARDIER DS250 2006 Shop Manual page 123

Section 03 ENGINE
Subsection 11 (GEARBOX)
vmr2006-076-007_a
1. Spindle
2. Shift fork
3. Shift drum
Remove output shaft, countershaft and reverse
shaft.
vmr2006-076-008_a
1. Output shaft
2. Countershaft
3. Reverse shaft
Remove drive shaft bearing setting plate.
CAUTION: Do not remove drive shaft needless-
ly. If removed, replace its bearing and seal.
104
vmr2006-076-009_a
Remove drive shaft towards inside of case.
vmr2006-076-010
Remove gasket and dowel pins.
Bearings
All bearings must turn smoothly and freely.
No excessive axial or radial play must be detected
during inspection.
Replace a defective or suspicious bearing with a
new one.
Always heat bearing bore up to 100°C (212°F) be-
fore removing its bearing. Use a heat gun.
WARNING
Clean oil, outside and inside, from case be-
fore heating. Oil is inflammable.
CAUTION: Always support the case properly
to remove bearing. Case damage may occur if
this procedure is not performed correctly.
Use a claw type hammer puller and pull from inner
race.
vmr2006-076