Position Light - BRP BOMBARDIER DS250 2006 Shop Manual

Section 05 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS AND ACCESSORIES)
vmo2006-014-067_a
RELEASE HOUSING FROM REAR FENDER
Remove lamp lens.
vmo2006-014-068_a
PULL ON LENS TO REMOVE
1. Lamp lens
Push bulb in and hold while turning counterclock-
wise to release.
Install the new bulb by first pushing in while turn-
ing clockwise.
Properly reinstall removed parts in the reverse or-
der of their removal.
Validate bulb works.

POSITION LIGHT

European Models
Test
Remove steering cover. Refer to STEERING AND
FRONT SUSPENSION.
Remove socket from position light.
Turn ignition switch on.
Turn headlamp switch either LO or HI.
Use a multimeter and set it to Vdc.
Read voltage as follows.
160
vmr2006-081-018_a
POSITION LIGHT SOCKET
WIRES
BROWN GREEN
There should be battery voltage. If so, replace
bulb.
If there is no voltage, measure voltage between
BROWN wire and battery ground.
If there is now voltage, check ground wire.
If there is still no voltage, check wiring harness
from headlamp switch.
Reinstall parts.
Bulb Replacement
vmo2006-014-069_a
BULB ACCESS
Pull on rubber bulb housing to gain access to bulb.
Replace bulb.
VOLTAGE
Battery voltage
vmr2006-081