Steering Column Bearing - BRP BOMBARDIER DS250 2006 Shop Manual

Check bearing seals for damages. Replace if nec-
essary.
Installation
For the installation, reverse the removal proce-
dure.
Apply synthetic grease XP-S (P/N 293 550 010) on
both seals when installing half housings.
Install a new cotter pin. Both ends of cotter pin
must be folded.

STEERING COLUMN BEARING

Removal
Remove front cover.
Remove CVT air inlet hose from front fender.
Move all wires and hoses out of holder.
vmr2006-083-026_a
1. Holder
Unlock locking tabs from steering bolts.
vmr2006-083-027_a
1. Locking tabs
2. Steering bolt
Loosen steering bolts.
Separate tie-rods from steering column.
Remove cotter pin and steering nut.
Lift up the steering column until it is free from
bearing.
Remove seal.
vmr2006-083
Section 07 STEERING AND FRONT SUSPENSION
Subsection 01 (STEERING AND FRONT SUSPENSION)
vmr2006-083-031
Remove circlip.
vmr2006-083-032
Using a suitable puller, remove bearing.
vmr2006-083-033
Installation
For installation, reverse the removal procedure.
To install the bearing, use the following items:
– bolt M8
– nut M8
– washer (P/N 224 081 301)
– large washer (P/N 517 302 322).
187