BRP BOMBARDIER DS250 2006 Shop Manual page 178

Remove front fender. Refer to BODY.
Unscrew retaining screw then pull out module.
Disconnect module.
Use a multimeter and set it to Vdc.
Activate indicator light switch and read voltage as
follows.
FLASHER MODULE INPUTS
TURN
(from hazard module)
SIGNAL
SWITCH
WIRE COLOR
Left turn ORANGE
LIGHT
Right turn
BLUE
If there is no voltage, check wiring harness from
hazard control module and ground wire.
If voltage is good, replace flasher module.
Hazard Lights
Since the same lights and modules are used as
for turn signal lights, perform the tests above. If
everything works, check hazard switch.
Hazard Switch
Disconnect connector with GREY and GREEN
wires coming from switch.
Use a multimeter and set it to .
Check switch as follows.
vmr2006-081-016_a
HAZARD SWITCH
SWITCH
WIRE COLOR
POSITION
OFF
GREY
ON
vmr2006-081
VOLTAGE
Pulsating battery
GREEN
voltage
RESISTANCE
Infinity (0L.)
GREEN
Close to 0
Section 05 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS AND ACCESSORIES)
If switch test failed, replace the auxiliary multi-
function switch. See STEERING AND FRONT
SUSPENSION.
Front Turn Signal Bulb Replacement
Remove rubber protector then pull on rubber bulb
housing to gain access to bulb.
Replace bulb.
vmo2006-014-071
PULL ON BULB HOUSING TO REMOVE
Validate bulb works.
Rear Turn Signal Bulb Replacement
Unscrew housing cover screws and lower housing
retaining screws.
vmo2006-014-065_a
1. Housing cover screws
2. Lower housing screws
3. Housing cover
4. Housing
Release housing from rear fender then remove
lamp housing.
159