BRP BOMBARDIER DS250 2006 Shop Manual page 172

vmr2006-081-003_a
Turn ignition switch on.
Select LO beam at headlamp switch.
Use a multimeter and set it to Vdc.
Measure relay supply voltage as follows.
vmr2006-081-008_a
RELAY SUPPLY VOLTAGE
WIRE COLOR
WHITE
GREEN
If voltage test failed, check ground wire. If it is
good, continue testing.
Use a multimeter and set it to .
Measure relay winding resistance as follows.
vmr2006-081
Subsection 04 (LIGHTS AND ACCESSORIES)
VOLTAGE
Battery voltage
Section 05 ELECTRICAL SYSTEM
vmr2006-081-009_a
WHITE TERMINALS
RELAY WINDING RESISTANCE
WHITE TERMINALS
1 2
If out of specification, replace relay.
Reconnect relay connector.
Disconnect HI beam relay connector.
vmr2006-081-003_a
Turn ignition switch on.
Select HI beam at headlamp switch.
Use a multimeter and set it to Vdc.
Measure relay supply voltage as follows.
RESISTANCE
Approximately 110
153