Master Cylinder Of Rear Brake Pedal - BRP BOMBARDIER DS250 2006 Shop Manual

vmr2006-085-024_a
Then, remove pin to separate yoke and rear brake
pedal.
vmr2006-085-025_a
Remove the big E-clip retaining rear brake pedal to
frame.
vmr2006-085-026_a
Pull rear brake pedal and remove the washer.
vmr2006-085-027_a
Installation
The installation is the reverse of the removal pro-
cedure.
vmr2006-085
Section 09 BRAKING SYSTEM
Subsection 01 (FRONT AND REAR BRAKES)
Apply suspension synthetic grease (P/N 293 550
033) on shaft before installing rear brake pedal.
MASTER CYLINDER OF REAR
BRAKE PEDAL
Removal
Drain rear brake pedal circuit. Refer to BRAKE
FLUID REPLACEMENT in this section.
Remove E-clip holding yoke to the end of brake
pedal.
vmr2006-085-024_a
Then, remove pin to separate yoke and brake ped-
al.
vmr2006-085-025_a
Unplug brake fluid reservoir hose from master
cylinder.
Remove Banjo fitting that attach brake hose to the
top of master cylinder. Discard sealing washers
and catch spilled fluid with a rag.
Remove bolts securing master cylinder to frame.
219