General; Procedures; Muffler; Exhaust Pipe - BRP BOMBARDIER DS250 2006 Shop Manual

Section 03 ENGINE
Subsection 04 (EXHAUST SYSTEM)

GENERAL

WARNING
Before performing any service or inspection
operation on the vehicle, wait until the engine
and exhaust have cooled down to avoid po-
tential burns.
WARNING
Always disconnect battery or starter cables
exactly in the specified order, BLACK (-) cable
first.
WARNING
Torque wrench tightening specifications
must strictly be adhered to.
Locking devices (ex.: locking tabs, elastic
stop nuts, self-locking fasteners, cotter pin,
etc.) must be installed or replaced with new
ones where specified. If the efficiency of
a locking device is impaired, it must be re-
newed.

PROCEDURES

MUFFLER

Removal
Remove screws and pull out heat shield.
vmr2006-069-001_a
Loosen muffler clamp.
38
vmr2006-069-002_a
Remove screws then pull out muffler.
vmr2006-069-004_a
Inspection
Check part for cracks, rust or any other default.
Also check mounting bracket area.
Installation
Installation is the reverse procedure of removal.

EXHAUST PIPE

Removal
Remove muffler.
Remove retaining nuts from cylinder head then
pull out exhaust pipe.
vmr2006-069