BRP BOMBARDIER DS250 2006 Shop Manual page 233

Section 09 BRAKING SYSTEM
Subsection 01 (FRONT AND REAR BRAKES)
vmr2006-085-010_a
1. LH reservoir cover
– Connect a clear hose to bleeding screw of pres-
sure control valve and loosen it. Place the other
end of hose in a container.
vmr2006-085-009_a
1. Pressure control valve
2. Brake hose toward LH handle lever
– Squeeze LH brake lever several times to drain
rear brake lever circuit completely.
– Using a big syringe, push brake fluid into brake
lever circuit by the bleeding screw of pressure
control valve.
vmr2006-085-011_a
1. Pressure control valve
2. Syringe with brake fluid
– Continue until reservoir is half full.
– Close bleeding screw.
– Fill reservoir.
NOTE: The reservoir is full when the fluid reaches
the top of window.
214
– Squeeze brake lever. It should be firm.
– If yes, install diaphragm and cover on reservoir.
– If not, bleed rear brake lever circuit as per pro-
cedure in BRAKE SYSTEM BLEEDING.
Rear Brake Pedal Circuit
To drain and fill the rear brake pedal circuit, use the
following procedure:
– Remove master cylinder reservoir cover of the
rear brake pedal.
vmo2006-014-032_b
1. Reservoir cover
– Connect a clear hose to bleeding screw of rear
caliper and loosen it. Place the other end of
hose in a container.
vmr2006-085-013
– Press brake pedal several times to drain rear
brake pedal circuit completely.
– To fill the circuit, connect a clear hose to bleed-
ing screw of pressure control valve and loosen
it. Place the other end of hose in a container.
vmr2006-085