Muffler Spark Arrester - BRP can-am COMMANDER 2017 Series Operator's Manual

MAINTENANCE PROCEDURES
tmr2011-011-025_a
ENTIRE FRONT END LIFTED
1. Ground level
A. 60 cm (24 in)
9. Lower vehicle to the ground.
10. Remove pressure cap and add
coolant as required.
11. Install pressure cap.
12. Lift driver's side of vehicle 60 cm
(2 ft) above it's horizontal position
for at least 1 minute.
tmr2011-011-026_a
DRIVER'S SIDE LIFTED
1. Ground level
A. 60 cm (24 in)
13. Lower vehicle to the ground.
14. Remove pressure cap and add
coolant as required up to the pres-
sure cap seat in the refill adapter.
______________
102
tmr2011-011-028_a
1. Cooling system refill adapter
2. Expansion tank hose
3. Coolant system full level (pressure cap seat)
15. Install the pressure cap.
16. Check coolant level in the coolant
expansion tank and fill to the MIN
level (as required).
17. Run engine at idle with the pres-
sure cap ON until the cooling fan
cycles on for a second time.
18. Stop the engine and let it cool
down.
WARNING
In order to avoid potential burns,
do not remove the pressure cap if
the engine is hot.
19. When the engine is cool, remove
pressure cap and add coolant if re-
quired.
20. Install pressure cap.
21. Check coolant level in the expan-
sion tank. Add coolant as required.
Refer to
LEVEL VERIFICATION

Muffler Spark Arrester

Muffler Spark Arrester Cleaning and
Inspection
CAUTION Never perform this
operation immediately after the en-
gine has been running as exhaust
system is very hot.
ENGINE COOLANT
.