Section 03 ENGINE
Subsection 07 (MAGNETO AND STARTER DRIVE)
GENERAL
Always disconnect battery.
WARNING
Always disconnect battery cables exactly in
the specified order, BLACK (-) cable first.
During assembly/installation, use the torque val-
ues and service products as in the exploded
views.
WARNING
Torque wrench tightening specifications
must strictly be adhered to.
Locking devices (ex.: locking tabs, elastic
stop nuts, self-locking fasteners, cotter pin,
etc.) must be installed or replaced with new
ones where specified. If the efficiency of
a locking device is impaired, it must be re-
newed.
PROCEDURES
MAGNETO COVER
Removal
Drain engine oil. Refer to LUBRICATION SYS-
TEM.
Drain engine coolant. Refer to COOLING SYS-
TEM.
Disconnect coolant hoses.
vmr2006-066-002_c
Remove magneto cover.
62
vmr2006-072-003_a
Remove dowel pins and gasket.
vmr2006-072-020_a
Inspection
Inspect bearing. See CRANKSHAFT END BEAR-
ING in this section.
Installation
Remove water pump cover.
Install dowel pins and a new gasket.
vmr2006-072