BRP BOMBARDIER DS250 2006 Shop Manual page 166

vmr2006-066-001_b
Clean starter area.
Remove starter mount screws.
vmr2006-080-001_a
Pull starter out.
Installation
Installation is the reverse of removal procedure.
However, pay particular attention to the following.
Make sure that starter and engine mating surfaces
are free of debris. Serious problem may arise if
the starter is not properly aligned. Tighten starter
screws.
Connect the RED (+) cable to the starter and tight-
en nut. Apply dielectric grease (P/N 293 550 004)
on terminal and nut.
First connect RED (+) cable to battery then con-
nect the BLACK (-) cable.
vmr2006-080
Section 05 ELECTRICAL SYSTEM
Subsection 03 (STARTING SYSTEM)
WARNING
Always connect RED (+) cable first then
BLACK (-) cable last. Whenever connecting
the RED (+) cable to the starter motor, make
sure the battery cables are disconnected to
prevent electric shock.
Test starter operation.
147