Section 05 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS AND ACCESSORIES)
HAZARD CONTROL
TURN
MODULE INPUTS
SIGNAL
SWITCH
WIRE COLOR
Left turn
PINK
Right turn
BROWN/WHITE
If there is no voltage, recheck as follows.
vmr2006-081-014_b
HAZARD CONTROL
TURN
MODULE INPUTS
SIGNAL
SWITCH
WIRE COLOR
Left turn
PINK
Right turn
BROWN/WHITE
If there is now voltage, check ground wire.
If there is no voltage, check wire from turn signal
switch.
Reconnect connector.
Output Signals from Hazard Control Module
IMPORTANT: Ensure hazard switch is OFF.
Turn ignition switch on.
Activate turn signal switch and read voltage as fol-
lows.
Disconnect 2-pin connector.
Use a multimeter and set it to Vdc.
Turn ignition switch on.
Activate turn signal switch and read voltage as fol-
lows.
158
VOLTAGE
Pulsating
battery
GREEN
voltage
VOLTAGE
Pulsating
Battery
battery
ground
voltage
vmr2006-081-015_a
HAZARD CONTROL
TURN
MODULE OUTPUTS
SIGNAL
SWITCH
WIRE COLOR
Left turn
ORANGE
LIGHT
Right turn
BLUE
If there is no voltage, replace hazard control mod-
ule.
If there is voltage, check wires from module to
turn signal lights.
Reconnect connector.
NOTE: To test the hazard lights system, set switch
to on and check output signals from module. Pul-
sating voltage must be present on both sides si-
multaneously. Otherwise, replace module.
Flasher Module
vmr2006-081-017_a
Check signals coming from hazard control module
as follows.
VOLTAGE
Battery
Pulsating
ground
battery voltage
vmr2006-081