TYPICAL
1. Hold piston while pushing circlip in place
2. Sleeve
3. Circlip installer
4. Direction to push circlip
5. Rag
CAUTION: Do not align circlip opening with pis-
ton cutout.
vmr2006-074-005_a
CORRECT POSITION
1. Circlip opening
2. Cutout
Install dowel pins and a new gasket.
vmr2006-074
Subsection 09 (PISTON AND CYLINDER)
vmr2006-074-006_a
Coat cylinder, piston and rings with engine oil.
Use a suitable ring compressor to compress and
hold rings while inserting cylinder.
Carefully insert cylinder over piston.
CAUTION: Do not force cylinder to enter piston.
This would damage ring(s).
vmr2006-074-007
TYPICAL
Install remaining components.
Section 03 ENGINE
89