BRP BOMBARDIER DS250 2006 Shop Manual page 154

vmr2006-079-013_a
2. Use a multimeter and set it to . Read resis-
tance as follows.
vmr2006-079-014_a
TRIGGER COIL
WIRE
BLUE/YELLOW and
GREEN/WHITE
Dynamic Test: Voltage
1. Disconnect trigger coil connector.
vmr2006-079
2. Use a multimeter and set it to Vac.
3. Set engine stop switch to RUN.
4. Press START button.
NOTE: On European models, set transmission to
Neutral and press any brake while starting.
5. Read voltage as follows.
RESISTANCE
446 - 545
6. Repeat test 3 times.
7. Reconnect connectors.
NOTE: Check wires condition and particularly
where they go out of magneto cover.
8. If trigger coil is out of specification, replace it.
Replacement
Refer to MAGNETO AND STARTER DRIVE.
Section 05 ELECTRICAL SYSTEM
Subsection 02 (IGNITION SYSTEM)
vmr2006-079-013_a
vmr2006-079-014_b
TRIGGER COIL
WIRE
BLUE/YELLOW and
GREEN/WHITE
If it tests good continue the other tests.
RESISTANCE
0.4 and 0.7 Vac
135