Choke Cable - BRP BOMBARDIER DS250 2006 Shop Manual

Section 04 FUEL SYSTEM
Subsection 01 (CARBURETOR AND FUEL TANK)
vmr2006-077-015_a
1. Throttle cable
2. Carburetor cover
3. Carburetor spring
4. Valve piston
Separate throttle cable from carburetor cover.
Remove throttle cable from vehicle.
Lubrication
The throttle cable must be lubricated with cable
lubricant (P/N 293 600 041) or an equivalent.
WARNING
Always use a silicone-based lubricant. Us-
ing another lubricant (like a water-based lu-
bricant) could cause the throttle lever/cable
sticking or stiffness.
To lubricate the throttle cable, remove cable from
throttle lever and from carburetor.
Install the cable luber (P/N 529 035 738) on cable.
Insert the needle of lubricant can on cable luber
hole.
WARNING
Always wear eye protection and gloves when
lubricating cables.
NOTE: Place a rag around cable luber to prevent
lubricant splash.
Put lubricant until it passes through the cable.
120
Place the cable in a vertical position during approx-
imately 15 minutes or until no lubricant flows out
of cable.
Reinstall and adjust cable, see below.
Installation
For installation, reverse the removal procedure.
Adjustment
WARNING
Ensure the key is turned OFF, prior to perform
the throttle cable adjustment.
Slide rubber protector back to expose throttle ca-
ble adjuster.
Loosen lock nut then turn the adjuster to obtain
correct throttle lever free play.
NOTE: Measure throttle free play at the tip of
throttle lever.
Tighten lock nut and reinstall protector.
vmo2006-014-052_a
TYPICAL
1. Throttle lever
2. Rubber protector
3. Cable adjuster
A. 1 to 3 mm (.039 to .118 in)
Tighten lock nut and reinstall protector.
With the transmission lever in NEUTRAL position,
start the engine. Check if the throttle cable is ad-
justed correctly by turning handlebar fully to the
right and left. If the engine RPM increases, read-
just the throttle cable or verify the cable routing.

CHOKE CABLE

Removal
NOTE: Before removing choke cable, note its
routing to ease the installation.
vmr2006-077