MAINTENANCE PROCEDURES
5. Continue adding coolant until sys-
tem is full up to the pressure cap.
6. Refill coolant tank up to MAX level
mark.
7. Run engine at idle with the radiator
cap off. Slowly add coolant if neces-
sary.
8. At this point, wait until engine
reaches normal operating tempera-
ture.
9. Depress the throttle lever two or
three times; then add coolant if re-
quired.
10. Stop the engine and let it cool
down.
11. Install coolant reservoir cap.
12. Inspect all connections for leaks
and check coolant level in the
reservoir.
Muffler Spark Arrester
Muffler Spark Arrester Cleaning and
Inspection
NOTE: Spark arrester screen replace-
ment is required only when damaged.
CAUTION Let exhaust system
cool down before proceeding with
cleaning and inspection.
Remove the muffler cover. Discard re-
taining screws.
NOTICE
Do not use impact tool for
any screw removal.
______________
154
219001961-007_a
TYPICAL
1. Screws
2. Cover
Remove and discard the tail pipe retain-
ing screws.
219001961-008_a
TYPICAL
1. Screws
2. Tail pipe
Remove exhaust tail pipe, gasket (dis-
card) and spark arrester.
tmo2011-001-041_a
TYPICAL
1. Spark arrester
2. Gasket
3. Exhaust tail pipe