Stator - BRP BOMBARDIER DS250 2006 Shop Manual

Section 05 ELECTRICAL SYSTEM
Subsection 01 (CHARGING SYSTEM)
Connect multimeter between fuse pins.
vmr2006-078-004_a
1. Fan fuse removed (10 A)
2. 30 A fuse removed
Read current.
TEST ENGINE SPEED
1500 RPM
If current is below specification, check magneto
(stator) prior to concluding that rectifier is faulty.
Reinstall fuses.
Dynamic Test: Voltage
Proceed as follows:
Slide rubber boot away from positive battery ter-
minal.
Set multimeter to Vdc scale.
Start engine.
Connect multimeter to battery posts.
vmr2006-078-005_a
Read voltage.
124
CURRENT
approx. 1.2 A
TEST ENGINE SPEED
1500 RPM
If voltage is above specification, replace voltage
regulator/rectifier.
If voltage is below specification, check wiring and
connections.
Properly secure battery positive terminal boot.
NOTE: If the battery will not stay charged, the
problem can be any of the charging system com-
ponents. If these all check good, try a new voltage
regulator/rectifier.

STATOR

Static Test: Continuity
Disconnect magneto wiring harness connector.
vmr2006-078-002_b
Set multimeter to .
Connect multimeter between YELLOW wires as
follows.
VOLTAGE
Max. 13.5 - 15 Vdc
vmr2006-078