Turn Signal Lights - BRP BOMBARDIER DS250 2006 Shop Manual

vmo2006-014-057_b
1. Bulb holder
2. Unlock (open)
3. Lock (close)
Properly reinstall removed parts in the reverse or-
der of their removal.
Unlock bulb holder by turning it counterclockwise.
Replace bulb.
Properly reinstall removed parts in the reverse or-
der of their removal.
Validate light works.
Headlamp Beam Aiming
Select high intensity.
Turn knob to adjust beam height to your conve-
nience or as per your local regulations. Adjust
both headlamps evenly.
All Models except Europe
vmo2006-013-007_b
1. Beam height adjustment
vmr2006-081
Section 05 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS AND ACCESSORIES)
European Models
vmo2006-014-058_a
1. Headlamp housing
2. Beam height adjustment

TURN SIGNAL LIGHTS

European Models
Tests
Check fuses. Refer to FUSES above.
NOTE: When turn signal switch or hazard switch
is turned on and turn signal lights do not flash,
check hazard control module and flasher module.
Remove lens. Refer to REPLACEMENT below.
Turn on ignition switch.
Position turn signal switch to the faulty side.
Using a multimeter, set it to Vdc.
Read voltage on socket terminals.
vmr2006-081-010_a
FRONT
155