BRP BOMBARDIER DS250 2006 Shop Manual page 210

vmr2006-083-036_a
Detach tie-rod from knuckle.
vmr2006-083-015_a
KNUCKLE SIDE
1. Cotter pin
2. Nut
3. Knuckle
Remove the lower ball joint nut.
vmr2006-083-038
Separate lower ball joint from knuckle.
Remove screws holding brake hose to lower
A-arm.
vmr2006-083
Section 07 STEERING AND FRONT SUSPENSION
Subsection 01 (STEERING AND FRONT SUSPENSION)
vmr2006-083-039_a
Remove bolts retaining A-arm to frame.
vmr2006-083-040_a
1. Lower A-arm
2. Bolts and nuts
3. Upper A-arm
Remove A-arm from vehicle.
Installation
NOTE: Install all bolts before torquing them.
Position A-arm on frame, then install bolts and
nuts.
Insert ball joint end into knuckle and install ball joint
nut.
Install shock absorber bolt.
Torque all bolts.
A-arm bolts
Shock
absorber bolt
Ball joint nut
TORQUE
49 N•m (36 lbf•ft)
45 N•m (33 lbf•ft)
49 N•m (36 lbf•ft)
Further tighten until one of its
grooves is aligned with a cotter pin
hole. Install a new cotter pin. Both
ends of cotter pin must be folded.
191