Muffler Spark Arrester - BRP CAN-AM OUTLANDER 6x6 2017 Series Operator's Manual

MAINTENANCE PROCEDURES
7. At this point, wait until engine
reaches normal operating tempera-
ture.
8. Depress the throttle lever two or
three times; then add coolant if re-
quired.
9. Stop the engine and let it cool down.
10. Install coolant reservoir cap.
11. Inspect all connections for leaks
and check coolant level in the
reservoir.

Muffler Spark Arrester

Muffler Spark Arrester Cleaning and
Inspection
NOTE: Spark arrester screen replace-
ment is required only when damaged.
CAUTION Let exhaust system
cool down before proceeding with
cleaning and inspection.
NOTICE
Do not use impact tool for
any screw removal.
Remove and discard the tail pipe retain-
ing screws.
vmr2012-0005-051_a
TYPICAL
1. Screws
2. Tail pipe
Remove exhaust tail pipe, gasket (dis-
card) and spark arrester.
______________
138
tmo2011-001-041_a
TYPICAL
1. Spark arrester
2. Gasket
3. Exhaust tail pipe
Remove carbon deposits from the
spark arrester using a brush.
NOTICE
Use a soft brush and be
careful to avoid damaging spark ar-
rester mesh.
CAUTION Wear eye protection
and gloves.
tmo2011-001-043_a
1. Clean spark arrester
Inspect mesh of spark arrester for any
damage. Replace as required.
NOTE: Spark arrester screen replace-
ment is required only when damaged
Inspect spark arrester chamber in muf-
fler. Clean any debris as required.
Install new gasket, tail pipe and new re-
taining screws.