Utility Screen - Yamaha AW2816 Owner's Manual

UTILITY screen

Using the test tone oscillator
Function
Select the waveform of the test tone
oscillator built into the AW2816, and
send it to the desired bus.
Key operation
• [UTILITY] key [F1] (Oscillator) key
• Repeatedly press the [UTILITY] key
until the screen shown at the right
appears.
Screen functions
A
Level meter
This shows the oscillator output level that is being
sent to buses 1–8 and AUX buses 1–6.
B
OSC ON (Oscillator On) button
This button turns the oscillator on/off (default set-
ting= off). When you move the cursor to this but-
ton and press the [ENTER] key, the button display
will change to "ON," and the oscillator signal will
be sent to the bus(es) you selected in the BUS
ASSIGN area (5). The oscillator level is controlled
by the LEVEL knob (3), and the waveform is
selected in the WAVEFORM area (4).
Tip!
• Sine waves and white noise have a higher sound pres-
sure level than they appear to your ears. Use caution,
since they may damage your speakers if played back
at a high volume.
• If you press the OSC ON button when the LEVEL
knob ( 3 ) is raised, high-volume sound may be out-
put suddenly. We recommend that you make sure
that the LEVEL knob is lowered before you turn on
the oscillator.
C
LEVEL knob
This knob adjusts the output level (–96 dB to 0 dB)
of the oscillator.
Oscillator page
2
3
D
WAVEFORM
Use the following buttons to select the waveform
of the test tone oscillator.
• SINE 100 Hz button ....... 100 Hz sine wave
• SINE 1 kHz button ......... 1 kHz sine wave
• SINE 10 kHz button ....... 10 kHz sine wave
• NOISE ............................ White noise
E
BUS ASSIGN
Use the following buttons to specify the bus to
which the oscillator signal will be sent.
• BUS 1–8 buttons ............ Buses 1–8
• AUX 1–6 buttons ............ AUX buses 1–6
• ST BUS button................ Stereo bus
Reference section
1
4
5
263