Yamaha AW2816 Owner's Manual page 88

Input/output patching
4
Quickly assigning input signals to tracks
Quick Rec is a function that lets you quickly switch
the patching so that the desired input signal can be
recorded on the desired track, while you view the
routing in a special screen. By using this function, you
can quickly record each instrument on its own track
without changing the INPUT jack connections.
1
Press the [QUICK REC] key.
The QUICK REC screen will appear. This screen
displays the following information.
1
1 MIX. CH
This area shows the type of input signals that are
assigned to input channels 1–8 (CH 1–CH 8). The
(jack) symbols displayed at the right of the box
indicate the direct output of each input channel.
B REC. TR
This area shows tracks 1–16 (TR 1–TR 16) of the
recorder section. The
at the left of the box indicate the inputs of each
track (recorder inputs 1–16).
2
If you want to change the input signal of a
patch source input channel, move the cur-
sor to the numerical box of that channel,
and turn the [DATA/JOG] dial.
80
(Quick Rec)
2
(jack) symbols displayed
Operation section
3
In the MIX. CH area, move the cursor to
the input channel jack for the desired
patch source, and press the [ENTER] key.
The selected input channel will be highlighted.
In the following illustration, input channel 7 has
been selected.
Tip!
If you move the cursor to the jack of a highlighted
input channel and press the [ENTER] key once again,
the selection will be cancelled.
4
Move the cursor to a jack symbol in the
REC. TR area, then move the cursor to the
recorder input (1–16) for the desired patch
destination, and press the [ENTER] key.
A patch cable will connect the patch source
direct output to the patch destination recorder
input.
Tip!
• Steps 3 and 4 can be performed in the opposite
order.
• The direct output of a channel can be patched to
multiple recorder inputs. However, it is not possible
to patch multiple direct outputs to one recorder
input.