Yamaha AW2816 Owner's Manual page 118

Editing tracks and virtual tracks
7
3
Move the cursor to the desired editing
command and press the [ENTER] key.
According to the editing command that you
selected, various buttons for setting the parame-
ters of that command will appear. Also, the
parameter setting area in the lower part of the
display will show the settings of the parameter
currently selected by the cursor. The following
illustration shows the example of when the
TRACK menu ERASE button is selected.
Parameter
Tip!
If you want to change your selection of an editing
command, move the cursor to the highlighted editing
command button, and press the [ENTER] key.
4
To edit the parameter settings, move the
cursor to the corresponding button and
press the [ENTER] key.
When you move the cursor to a button, the lower
part of the display will show the setting values of
that parameter. If you now press the [ENTER] key,
the cursor will move to the parameter setting
area, and you can edit the setting.
Tip!
For some editing commands, you will set the FR.
TRACK and TO TRACK parameters to specify the edit
source and edit destination tracks.
112
5
Use the [DATA/JOG] dial to edit the param-
eter settings.
Tip!
Parameters that specify a track 1–16 can also be set
by using the REC TRACK SELECT [1]–[16] keys instead
of the [DATA/JOG] dial.
The way in which a value is edited will depend on the
type of command or parameter. In some cases you
will use a controller other than the [DATA/JOG] dial.
For details refer to page 118 ,"Editing commands."
6
Press the [ENTER] key.
The parameter value will be finalized, and you
will return to step 3 (selecting the parameter).
Repeat steps 4–6 as necessary to edit other
parameters.
7
Move the cursor to the EXECUTE button
and press the [ENTER] key.
A popup window will ask you to confirm execu-
tion of the editing operation.
8
To execute the operation, move the cursor
to the OK button and press the [ENTER]
key.
The editing command you selected in step 3 will
be executed. When processing is completed, you
will return to step 1.
Tip!
To cancel execution, move the cursor to the OK but-
ton and press the [ENTER] key.
With the exception of the NAME command and
EXPORT command, you can press the [UNDO]
key immediately after execution to cancel the
result of the operation.
Operation section