Accessing Screens And; Switching A Button On/Off - Yamaha AW2816 Owner's Manual

Welcome to the world of the AW2816
2
Basic operation of the AW2816
This section explains basic operations of the AW2816,
such as screen operations and selecting channels.
Accessing screens and pages
When you want to operate a mix parameter or edit an
internal setting of the AW2816, you must first recall
the desired screen in the display. if a screen is divided
into multiple pages, select the desired page after
recalling the screen.
1
Press the key for the desired screen.
When you press a key in the top panel WORK
NAVIGATE, UNIT, MIXER, FADER MODE,
RECORDER, or AUTOMATION sections or the
[METER] key, the corresponding screen will
appear. For example, the following illustration
shows the PATCH screen that will appear when
you press the [PATCH] key of the UNIT section.
Tip!
If the screen contains multiple pages, the most-
recently operated page of that screen will appear.
2
To select another page within that screen,
press the function key ([F1]–[F5]) that cor-
responds to the desired page.
The tabs displayed at the bottom of the screen
correspond to the function keys ([F1]–[F5]) as
shown in the following illustration. For example
if you want to access the Patch OUT page of the
PATCH screen, press the [F2] key.
36
Tip!
• You can also move successively between the pages
of a screen by repeatedly pressing the same key in
step 1.
• In this manual, consecutive key operations are listed
as "[PATCH] key
and then press the [F2] key).

Switching a button on/off

A button displayed in the screen can be switched on/
off as follows.
1
Use the CURSOR keys to move
the cursor to the desired button.
2
Press the [ENTER] key.
The button will be switched on/off. A
highlighted button is currently "on."
Editing the value of a fader/
knob/numerical box
The value of a fader/knob/numerical box displayed in
the screen can be edited as follows.
1
Use the CURSOR keys to move the cursor
to the desired fader/knob/numerical box.
2
Turn the [DATA/JOG] dial to edit the value.
Operation section
[F2] key" (press the [PATCH] key