Yamaha AW2816 Owner's Manual page 321

Monitor the output levels of buses
Function
Monitor the output level of buses 1–8
and AUX buses 1–6. In this page you
can also adjust the master level of each
bus.
Key operation
• [HOME] key [F2] (Bus) key
• Repeatedly press the [HOME] key
until the screen shown at the right
appears.
Screen functions
A
Level meters
These indicate the output level for each bus.
B
Faders
These faders adjust the master level for each bus.
To adjust the position of a fader, move the cursor
to the desired fader and turn the [DATA/JOG] dial.
The position of the fader for each bus is displayed
in dB units below each fader.
Tip!
If buses are paired, a heart symbol will be displayed
between the corresponding odd-numbered
numbered buses. Pairing settings are made in the PAN/
ROUTE screen Pair page.
C
PRE FADER button
D
POST FADER button
Use these two buttons to select the location within
the signal routing at which the level will be indi-
cated by the level meters (1). Turning on the PRE
FADER button will display the pre-fader (3) signal
level, and the POST FADER button will display the
post-fader signal level.
Bus page
2
3
...
E
STEREO OUT LEVEL
This displays the position of the STEREO fader in
dB units.
even-
Additional functions in the Bus page
In the Bus page you can press the [SHIFT] key to
assign the following function to the [F1] key.
• [F1] (PEAK HOLD) key
Switches the Peak Hold function on/off. When
peak hold is on, a "
peak level will be maintained in the level meter
(1). The peak hold setting also affects the level
meters displayed in pages other than in the EQ/
ATT/GRP screen and the DYN/DLY screen.
Reference section
1
4
PRE FADER POST FADER
...
METER METER
LEVEL
METER METER
LEVEL
" symbol indicating the
5
BUS 1(...8)
AUX 1(...6)
319