Yamaha AW2816 Owner's Manual page 209

With these settings, operating a parameter will
cause the corresponding parameter change to be
transmitted. When a parameter change is
received from an external device, the corre-
sponding parameter will be controlled.
4
Put your MIDI sequencer in record-ready
mode, and play back the AW2816 song.
Both devices will begin running in synchroniza-
tion.
5
Operate a parameter on the AW2816.
Parameter change messages corresponding to the
parameter movements will be transmitted from
the MIDI OUT/THRU connector or TO HOST
connector, and will be recorded on your MIDI
sequencer.
6
When you have finished operating the
parameter, press the STOP [
the song.
The MIDI sequencer will also stop.
7
Put the MIDI sequencer in playback-ready
mode.
8
On the AW2816, locate to a location earlier
than where you recorded the parameter
operation, and play back the song.
The MIDI sequencer will play back in synchroni-
zation with the AW2816. When the AW2816
receives parameter change messages from the
MIDI sequencer, the corresponding parameters
will change.
] key to stop
Operation section
13
205