Yamaha AW2816 Owner's Manual page 57

When the AW2816 is in the default state, the
outputs of buses 1–8 (BUS 1–BUS 8) are assigned
to recorder inputs 1–8/9–16 as shown in the dia-
gram below.
Recorder
input patch
Mixer section
Buses 1–8
4
Move the cursor to the RECORDER TRACK
INPUT ASSIGN area. Change the recorder
input 1 setting to "DIR 1," and the
recorder input 2 setting to "DIR 2."
The DIR 1–DIR 8 settings indicate the direct out-
put (with the initial settings, the post-fader input
signal) of input channels 1–8. As shown in the
diagram below, patching "DIR 1" and "DIR 2" to
recorder inputs 1/2 will cause the input signal of
input channels 1/2 to be sent directly to tracks 1/
2.
5
Press the REC TRACK SELECT [1]/[2] keys.
The REC TRACK SELECT [1]/[2] keys will begin
blinking, and tracks 1/2 will be in record-ready
mode.
6
Press the [METER] key.
The METER screen will appear, displaying meters
that indicate the input/output levels of tracks 1–
16.
Recorder section
8
Tracks 1–8
8
Tracks 9–16
Operation section
Tip!
The METER screen has two pages, Meter 1 and Meter
2, and you can switch between these by using the
[F1]/[F2] keys or by repeatedly pressing the [METER]
key. The functions of the meter area are the same for
both pages.
7
In the INPUT MONITOR area, make sure
that the AUTO button is on.
The three buttons in the INPUT MONITOR area
located in the lower right of the METER screen
are used to select the input metering mode (the
way in which input metering of each track is
switched). When the AUTO button is on, the sig-
nal being monitored for record-ready tracks will
change automatically depending on the running
mode, as shown in the following table.
Running mode
Stopped
Playing
Recording
8
While playing sounds on the instrument
connected to the INPUT 1/2 jacks, check
level meters 1/2.
The level of the signals input to tracks 1/2 will be
displayed in level meters 1/2. (However at this
stage, they will not yet be output to the MONI-
TOR OUT jacks/PHONE jack.) If the level meters
reach the OVER position, check whether the
fader 1/2 (input level of input channels 1/2) set-
tings are appropriate.
Tip!
You can use the Quick Rec screen to make the settings
of steps 1–6 in a single operation. For details on the
Quick Rec function, refer to page 80.
Monitored signal
Track input source
Track playback
Track input source
49
3