Yamaha AW2816 Owner's Manual page 202

MIDI
13
7
On the MTC slave AW2816, press the
[MIDI] key
Setup 1 page.
8
Move the cursor to the SLAVE button of
the MTC SYNC area, and press the [ENTER]
key to turn it on.
The corresponding AW2816 will be set to func-
tion as the MTC slave.
9
Move the cursor to the MASTER button of
the MMC MODE area, and press the
[ENTER] key to turn it on.
The MTC slave AW2816 will be set to function as
the MMC master.
10
On the MTC slave AW2816, press the
[SETUP] key
screen/D.In Setup page.
11
Move the cursor to the D.ST IN button of
the WORDCLOCK SOURCE area, and press
the [ENTER] key.
The clock data included in the signal that is input
from the DIGITAL STEREO IN jack of the MTC
slave AW2816 will be selected as the word clock
source. In this state, the MTC slave AW2816 will
also be the word clock slave.
198
[F1] key to access the MIDI
— MTC slave unit —
[F1] key to access the SETUP
— MTC slave unit —
If the sampling frequency of the two AW2816 units is
not the same, the word clock signal will not lock, and
playback will not occur correctly on the MTC slave
during synchronized playback. If you want two
AW2816 units to play back in synchronization, the
sampling frequency of both songs must be the same.
12
Move the cursor to the button marked DIS-
ABLE in the STEREO BUS CASCADE area,
and press the [ENTER] key.
The button display will change to ENABLE, and
the stereo bus signal received from the MTC mas-
ter/word clock master unit via the DIGITAL STE-
REO IN jack will be sent directly to the stereo
bus of the MTC slave/word clock slave.
Tip!
• If you have cascade-connected two AW2816 units,
you should generally set the STEREO fader of the
word clock master at nominal level (0 dB).
• By using the ATT. encoder in the STEREO BUS CAS-
CADE area, you can adjust the input level of the
DIGITAL STEREO IN jack (in this case, the level of
the signal sent from the MTC master/word clock
master AW2816).
13
On the MTC slave AW2816, press the PLAY
[ ] key.
The MTC master/word clock master will begin
running, and will output MTC. The MTC slave/
word clock slave AW2816 will follow this MTC,
and begin running. The stereo channel output of
the MTC master/word clock master will be sent
directly to the stereo bus of the MTC slave/word
clock slave.
Word clock master
Stereo output channel
Word clock slave
Input channels
Monitor channels
Return channels
Stereo output channel
Operation section
— MTC slave unit —
DIGITAL STEREO
OUT jack
ST bus
DIGITAL STEREO
IN jack
DIGITAL STEREO
OUT jack