Yamaha AW2816 Owner's Manual page 106

Transport/Locate operations
6
You can specify a locate point numerically, and locate
to that point.
1
With the transport stopped, press the
[NUM LOCATE] key.
The [NUM LOCATE] key will blink, and the cur-
sor will move to the counter in the upper part of
the display.
2
Use the [DATA/JOG] dial or the numeric
keys to specify a locate point.
A locate point can be specified using either of
the following two methods.
• Using the [DATA/JOG] dial
With this method you can move the cursor left or
right to specify the unit that you want to change,
and turn the [DATA/JOG] dial to change the
value. When the counter is displaying time, you
can specify hours/minutes/seconds/milliseconds.
When it is displaying time code, you can specify
hours/minutes/seconds/frames/sub-frames. When
it is displaying measures, you can specify mea-
sures/beats.
• Using the numeric keys to directly input a value
With this method you can use the [0]–[9] keys of
the Locate section to directly input a numerical
value. When time display is selected for the
counter, pressing
[1] [5] [2] [3] [0] [0] [0] will input
"00:15:23.000".
You can also move the cursor to the left and
input only the upper places. In this case, the val-
ues to the right of the cursor will be set to 0.
For example if the counter is displaying time, you
can move the cursor to the seconds unit and
press [1] [5] [2] [3] to input "00:15:23.000".
100
Locating to a specified point
Cursor
Operation section
Tip!
If you want to locate to a negative location, use the
[ ] key to specify the minus sign. Each time you
press the [ ] key, the minus sign will alternately
turn on/off.
3
To locate to the specified location, press
the [ENTER] key.
The song will move to the specified location. If
you want to cancel your input and return to the
previous value, press the [CANCEL] key.