Utility Screen; Oscillator Page; Using The Test Tone Oscillator - Yamaha AW4416 Reference Manual

UTILITY screen

Using the test tone oscillator

[Function]
Select the waveform of the test
tone oscillator built into the
AW4416, and send it to the
desired bus.
[Key operation]
• [UTILITY] key [F1] (Oscillator)
key
• Repeatedly press the [UTILITY]
key until the screen shown at the
right appears.
[Mouse operation]
M button UTIL button
lator tab
[Screen functions]
A Level meter
This shows the oscillator output level that is
being sent to buses 1–8 and AUX buses 1–8.
B
OSC ON (oscillator on) button
This button switches the oscillator on/off.
(Default=OFF)
Sine waves and white noise have a higher
sound pressure level than they appear to your
ears. Use caution, since they may damage
your speakers if played back at a high vol-
ume.
C
LEVEL knob
This knob adjusts the output level (–96 dB–
0 dB) of the oscillator.
D WAVEFORM
Use the following four buttons to select the
waveform of the test tone oscillator.
• SINE 100 Hz button ..... 100 Hz sine wave
• SINE 1 kHz button ....... 1 kHz sine wave
• SINE 10 kHz button ..... 10 kHz sine wave
• NOISE .......................... White noise

Oscillator page

2
3
Oscil-
1
E BUS ASSIGN
Use the following buttons to specify the bus to
which the oscillator signal will be sent.
• BUS 1–8 buttons .......... Buses 1–8
• AUX 1–8 buttons.......... AUX buses 1–8
• ST BUS button ............. Stereo bus
Tip!
You can specify more than one bus as the
oscillator output destination.
4
5
33
— Reference Guide