Installing A Cd-Rw Drive; About The Cd-Rw Drives; Cd-Rw Drive Settings - Yamaha AW2816 Owner's Manual

Before you begin

About the CD-RW drives

A CD-RW drive is an option that allows you to create
music CD's, to backup/restore internal hard disk data,
to play a music CD or to read a CD-ROM. An inter-
nal-type CD-RW drive can be installed by removing
the CD-RW drive cover from the front panel. CD-RW
drives with the following specifications can be used.
• Interface: ATAPI
• Models known to work: consult your local
Yamaha distributor or refer to the website at the
following URL.
<http://www.aw2816.com/>
• CD-RW drives designed for internal installation can
be installed in the AW2816. Please be aware that
internal CD-RW drives designed for use with the
AW4416 cannot be used in the AW2816.
In the case of external SCSI-connected CD-RW
drives, a CD-RW drive usable with the AW4416 can
also be used with the AW2816.
• By "models known to work," we mean commercially
available models that Yamaha has obtained, installed
in the AW2816, and successfully tested by means of
various operational tests. However, we cannot take
into account slight differences in performance that
may occur due to the manufacturing tolerances of
each manufacturer.
• Please be aware that Yamaha Corporation will
accept no responsibility for any damages, neither
direct nor indirect, resulting from the use of any of
the above CD-RW drives.
4

Installing a CD-RW drive

Operation section

CD-RW drive settings

Insert the jumper (included with the CD-RW drive)
into the jumper switch on the rear panel of the CD-
RW drive to set your CD-RW drive to function as a
SLAVE unit. The AW2816 will not start up if the CD-
RW is set to a mode other than SLAVE.
• If you are installing a CD-RW drive manufac-
tured by Yamaha, it will be set to SLAVE when
shipped from the factory, so you do not need to
change the setting.
CSEL
SLAVE
MASTER
Set to SLAVE
Jumper switch
For details on this setting, refer to the manual that
came with your CD-RW drive.
* Note that the cover panel of the AW2816 cannot be
attached to a CD-RW drive with a lid-type tray. The
AW2816's cover panel can be attached to a CD-RW
drive with a tray of the following dimensions.
Maximum 138 mm
Jumper