Stereo Output Channel; Output Patch - Yamaha AW2816 Owner's Manual

Stereo output channel

This is a stereo output channel that processes the sig-
nals sent from each channel to the stereo bus. It pro-
vides a 4-band EQ and dynamics processor identical
to those provided on the input channels. The output
signal of the stereo output channel is sent via the out-
put patch section to the various output jacks, and is
also simultaneously output to the MONITOR OUT
jacks and PHONES jack.
When you use an internal or external CD-RW drive to
play back an audio CD, the CD audio signal is
patched to the pre-fader location of the stereo output
channel.
...
DY-
ATT 4BAND EQ NAMICS
METER
(EQ)
DY-
ATT 4BAND EQ
NAMICS
METER METER
(EQ) (Gain Reduction)
Buses 1–8
The signals sent from each channel to buses 1–8 pass
through a master level, and are sent to the output
patch section. The master level of buses 1–8 is con-
trolled in the HOME screen Bus page.
AUX buses 1–6
The signals sent from each channel to AUX buses 1–6
pass through a master level, and are sent to the output
patch section. The master level of AUX buses 1–6 is
controlled in the HOME screen Bus page.
...
METER
METER
Tip!
With the AW2816's default settings, the output of
AUX buses 5/6 is sent to the output patch section, and
also assigned to the input of internal effects 1/2.
METER
INSERT
ON LEVEL
METER
CD PLAY mode
L
CD PlayBack
R
CD-RW DRIVE
METER
LEVEL BUS 1(...8)
METER
LEVEL AUX1(...6)
Operation section
STEREO
METER
BAL
METER
2
31