Yamaha AW2816 Owner's Manual page 395

MAKE NEW MIX.
MARK ERASED
MARK SET
MEMORY FULL!!
MIDI BULK RECEIVED
MIDI IN: DATA FRAMING ERROR!
MIDI IN: DATA OVERRUN!
MIDI: RX BUFFER FULL!
MIDI: TX BUFFER FULL!
NO CURRENT AUTOMIX.
NO DATA TO PATCH
NO DATA TO RECALL.
NO MARK LEFT
NO MEDIA!!
NO PATCH CORD LEFT
PLAY TRACK MUTE IS ON
RECORDER BUSY
RECORDER RUNNING
REDO COMPLETE
REPEAT POINTS TOO CLOSE
SELECTED ALL TRACKS
SELECTED AREA HAS NO DATA.
SELECTED AREA HAS NO REGION.
SELECTED CH IS NONE.
SELECTED CH ONLY MODE.
SELECTED SONG HAS NO REGION.
SELECTED TRACK HAS NO REGION.
SELECTED TRACK NOT RECORDED.
SLOT INPUT SYNC ERROR!
SOLO READY.
SOLO SLAVE.
SONG NUMBER FULL.
SONG TOP/END OUT OF RANGE
STEREO PAIRED.
STEREO TRACK MUTE IS OFF
There are no events to be edited. Please create a new mix.
The mark has been erased.
The mark has been set.
The song has no more free space. One song can use a maximum of
6.4 GB.
A bulk data dump was received.
Invalid data may have been received at the MIDI IN connector.
Invalid data may have been received at the MIDI IN connector.
Receiving more MIDI data than it can handle.
Attempting to transmit more MIDI data than it can handle.
There is no valid automix data. Please create a new mix.
No Quick Rec patch has been specified.
Since data has not been stored, it cannot be recalled.
The allowable number of marks has been exceeded.
Media has not been inserted.
You attempted to patch in excess of what is allowed by Quick Rec.
Playback tracks were muted because the allowable number of simul-
taneously recorded/played tracks was exceeded.
The operation cannot be executed because the recorder is operating.
The operation cannot be executed because the recorder is recording
or playing.
Redo (re-execution of the previous operation) has been completed.
The repeat interval is too short. It cannot be set to less than one sec-
ond.
Since all tracks are selected, it is not possible to export to CD-R/RW
media, or to edit the track name.
The selected area contains no trigger data.
The selected area contains no region.
The selected channel cannot be selected since it does not exist.
The channel cannot be changed, since the display mode is set to
SELECTED CH ONLY.
The selected song does not contain a region.
The selected track does not contain a region.
The selected track does not contain recorded data.
The signal being input to the input jack of a card installed in OPTION
I/O slot is not synchronized to the word clock master.
The Solo function is ready. Use the [SEL] keys to select the solo chan-
nel.
The Solo status cannot be changed when the AW2816 is functioning
as a cascade slave. Press the Solo key on the master console.
The maximum number of songs has been reached.
You located outside the top/end range of the song.
You are attempting to defeat ST LINK for the dynamics of paired chan-
nels.
Since muting is off for the stereo track, track muting cannot be turned
off.
Appendix
393