Yamaha AW2816 Owner's Manual page 110

Transport/Locate operations
6
Editing the location of a locate point
The location of the Start point, End point, A/B points,
In/Out points, or Markers can be edited if desired.
1
Press the [TRACK] key
The TRACK screen MARK Adj. page will appear.
The LOCATOR POSITION area in the upper part
of the screen shows the location of each cur-
rently-set locate point. The MARKER POSITION
area in the lower part of the screen lists the cur-
rently-set markers.
A point
In point
Start point
Markers
Tip!
The numeric boxes will indicate "–" for locate points
that have not been set.
2
Move the cursor to the desired locate
point.
Tip!
• The Start point and End point will always use time
code display, regardless of the currently selected
display method.
• The numerical position of locate points other than
the Start point and End point will depend on the
currently selected counter display method (hours/
time code/measures).
3
Use the CURSOR [
the unit that you want to edit, and use the
[DATA/JOG] dial to edit the value.
If the counter is set to time display you can edit
"hours/minutes/seconds/milliseconds." If it is set
to time code display you can edit "hours/min-
utes/seconds/frames/sub-frames." If it is set to
measure display you can edit "measures/beats."
104
or marker
[F4] key.
B point
Out point
End point
]/[ ] keys to select
Operation section
4
To adjust the location of a marker, move
the cursor to the numeric box in the left of
the MARKER POSITION area, and turn the
[DATA/JOG] dial to select the desired
marker number.
5
Use the CURSOR [
the unit that you want to edit, and use the
[DATA/JOG] dial to edit the value.
When editing the location of a marker, it is not possi-
ble to move the marker past the preceding or follow-
ing marker.
]/[ ] keys to select