Yamaha AW2816 Owner's Manual page 234

Monitor the signal
Make settings so that the input signal sent to recorder
inputs 1/2 can be monitored via the stereo output
channel from the MONITOR OUT jacks/PHONES
jack.
6
Press the REC TRACK SELECT [1]/[2] keys.
REC TRACK SELECT [1]/[2] keys will blink, and
tracks 1/2 will be in record-ready mode.
7
Press the [PAN] key
to access the PAN/ROUTE screen/Pan
MONI page, and turn the ST button on for
monitor channels 1/2. Also turn off all bus
assign 1-8 buttons.
The input signal of tracks 1/2 (the bus 1/2 signal)
will be sent via monitor channels 1/2 to the ste-
reo bus.
8
Set the monitor channel 1 PAN knob to the
far left (L16), and the monitor channel 2
PAN knob to the far right (R16).
9
Press the RECORDER [1-8] key to select
monitor channels 1–8 as the mixing layer.
10
Make sure that the monitor channel 1/2
[ON] keys are turned on, and raise faders
1/2 and the STEREO fader to the 0 dB posi-
tion.
With these settings, the input signals will pass
through monitor channels 1/2 and the stereo out-
put channel, and can be monitored from the
MONITOR OUT jacks/PHONES jack.
[F2] (Pan MONI) key
Operation section
Create a mix and record
Now we will adjust the mix balance of the input
channels, and record the result on tracks 1/2.
11
Press the [METER] key.
The METER screen will appear. In this screen you
can view the input/output levels of the tracks 1–
16 and the output level of the stereo output
channel. Play your instrument(s), and verify that
the track 1/2 and stereo output channel meters
respond.
Tip!
The METER screen contains a Meter 1 page and a
Meter 2 page, but you may select either one.
12
Press the INPUT [1-8] key to select input
channels 1–8 as the mixing layer.
13
While watching the meters (input level) for
tracks 1/2, operate the input channel 1–4
faders to set the mix balance.
It will not be possible to adjust the mix balance of
each audio source after they are recorded on track 1/
2.
Tip!
If the stereo output channel (L/R) meter clips, lower
the monitor channel faders or the STEREO fader.
14
When you have finished setting the bal-
ance, press the REC [ ] key + PLAY [
key to begin recording.
]
14
231