Yamaha AW2816 Owner's Manual page 304

DYN/DLY screen
Dynamics processor settings
Function
Make dynamics processor settings for
the selected channel
Key operation
• [DYN] key [F1] (Dyn. Edit) key
• Repeatedly press the [DYN] key until
the screen shown at the right appears.
Screen functions
A
KEY IN SOURCE
Use the following buttons to select the signal (key-
in) that will trigger the dynamics processor.
• SELF (POST EQ) button
The post-EQ signal of the currently selected chan-
nel
• SELF (PRE EQ) button
The pre-EQ signal of the currently selected chan-
nel
• AUX1 OUT button
The signal immediately before the master send
level of the AUX 1 bus
• AUX2 OUT button
The signal immediately before the master send
level of the AUX 2 bus
• LEFT (POST EQ) button
The post-EQ signal of the adjacent channel to the
left
• LEFT (PRE EQ) button
The pre-EQ signal of the adjacent channel to the
left
• If input channel 1, monitor channel 1, or the stereo
output channel is selected, the LEFT (POST EQ)/LEFT
(PRE EQ) buttons will be unavailable.
• Because return channels 1/2 do not have dynamic
processors, the items of this page will not be dis-
played if a return channel is selected.
302
Dyn. Edit page
1
3
4
B
Channel
When the LEFT (POST EQ) or LEFT (PRE EQ) but-
ton is turned on in KEY IN SOURCE (1), this dis-
plays the key-in source channel.
C
ST LINK (Stereo link)
If the button in this area is turned on, the dynamics
processor settings and operation will be linked for
adjacent odd-numbered
nels. In this case, both channels will operate
simultaneously if either channel exceeds the
threshold level.
To turn the button on, move the cursor to the box
at the right, and select one of the following as the
channel(s) for which the dynamic processor will
be enabled.
• BOTH .................. Both odd-numbered and
• L .......................... Only the odd-numbered (left)
• R.......................... Only the even-numbered
Tip!
• The button in the ST LINK area will always be on for
the stereo output channel and for paired channels. (It
will not be possible to turn it off.)
• When you turn on the button in the ST LINK area,
the dynamics processor settings of the odd-num-
bered channel will be copied to the even-numbered
channel.
Reference section
2 5 6
even-numbered chan-
even-numbered channels
channel
(right) channel
7
8
9