Yamaha AW2816 Owner's Manual page 93

Using the internal effects
5
Switching between pre-fader/
post-fader
Here's how to select the output position (pre-fader/
post-fader) from which the signal will be sent from
each channel to AUX bus 5.
1
Press the [AUX 5] key
The AUX5/EFF1 screen Pre/Post page will appear.
Here you can select either pre-fader or post-fader
as the point from which the signal will be output
from each channel to AUX bus 5 and sent to
effect 1.
1
2
3
4 5
A
Input channels
B
Monitor channels
C
Return channel
D
PRE/POST button
E
ON/OFF button
86
[F3] key.
Operation section
2
To switch between pre-fader and post-
fader, move the cursor to the PRE/POST
button of the corresponding channel, and
press the [ENTER] key.
Each time you press the [ENTER] key, the display
will alternate between PRE (pre-fader) and POST
(post-fader). (With the default settings of the
song, all channels will be set to POST.)
If PRE (pre-fader) is selected, the signal can be
sent to AUX bus 5/effect 1 without regard to the
position of the channel faders. If POST (post-
fader) is selected, the signal that has passed
through the faders will be sent to AUX bus 5/
effect 1. (This means that no effect will be
applied to a channel whose fader is turned
down.)
Tip!
• If you move the cursor to the PRE button or POST
button in the GBL area at the right of the display
and press the [ENTER] key, all channels will switch
to pre-fader or post-fader.
• It is not possible to send the signal from return
channel 1 to effect 1 (AUX bus 5), or from return
channel 2 to effect 2 (AUX bus 6). This is to prevent
a loop from occurring between the return channel
and the effect.
• Because of the reason described above, return chan-
nel 1 (return channel 2) is not displayed in the
AUX5/EFF1 screen (AUX6/EFF2 screen) Pre/Post
page.
3
Make sure that the ON/OFF button is
turned ON for each channel to which you
want to apply the effect.
The ON/OFF buttons are used to switch the AUX
send on/off for each channel. If a button is turned
OFF, move the cursor to that button and press the
[ENTER] key.