Yamaha AW2816 Owner's Manual page 73

6
To rehearse auto punch-in/out, press the
PLAY [ ] key.
A
The PLAY [ ] key will light, and playback
will begin from the pre-roll point.
B
When you reach the auto punch-in point, the
REC [ ] key will begin blinking, and the sig-
nal being monitored for the track you
selected in step 3 will switch from the track
playback sound to the input signal (the
recording source). However, recording will
not actually occur.
C
When you reach the auto punch-out point,
the REC [ ] key will go dark, and the signal
being monitored will switch back to the track
playback sound.
D
When you reach the post-roll point, the trans-
port will return to the pre-roll point and stop.
7
If you want to rehearse again, press the
PLAY [ ] once again while stopped.
Tip!
If you press the [REPEAT] key before or during
rehearsal, operations 1 – 4 of step 6 will be repeated.
(The A-B Repeat function will be disabled during this
time.) If you want to stop repeating rehearsal, press
the [REPEAT] key once again or press the STOP [ ]
key.
8
9
The following diagram shows the auto punch-in/out
procedure.
Pre-roll
point
1
2
3
16
Locate
REC TRACK
SELECT
Rehearsal
Actual
recording
Operation section
To actually perform auto punch-in/out,
make sure that the transport is stopped,
and hold down the REC [ ] key and press
the PLAY [ ] key.
A
The PLAY [ ] key will light, the REC [ ]
will blink, and playback will begin from the
pre-roll point.
B
When you reach the auto punch-in point, the
REC [ ] key will change from blinking to
steadily lit, and recording will begin on the
track you selected in step 1 (punch-in).
C
When you reach the auto punch-out point,
the REC [ ] key will resume blinking,
recording will be defeated, and you will
return to playback mode (punch-out).
D
When you reach the post-roll point, the trans-
port will return to the pre-roll point and stop.
If you want to listen to the recorded result,
press the [AUTO PUNCH] key to make it go
dark, and then press the PLAY [
Tip!
If you make a mistake while recording with auto
punch-in/out, press the [UNDO] key while stopped.
The previous recording operation will be cancelled,
and the state before recording will be recovered.
Auto
punch-in punch-out
point
Playback Rehearsal
Playback Recording
3
] key.
Auto
Post-roll
point point
Playback
Playback
65