Yamaha AW2816 Owner's Manual page 188

7
Move the cursor to the stereo track infor-
mation in the list, and use the [DATA/JOG]
dial to select the stereo track that will be
written to track 1.
In this list, it is not possible to select stereo tracks that
are part of a 48 kHz sampling frequency song, or the
stereo track of a current song that has not been saved
on the hard disk. In addition, there may be cases in
which it will not be possible to select the stereo track
of a song that has not been optimized. (For details on
the Optimize operation, refer to page 154.)
8
If you want to permit digital copying of the
track you selected in step 7, move the cur-
sor to the COPYRIGHT button located in
the lower part of the screen, and press the
[ENTER] key.
The COPYRIGHT button specifies whether copy-
prohibit flags will be written into the sub-code
channel of the CD. If the button is set to PRO-
HIBIT, the COPY column of corresponding track
will show a symbol, and digital copying of
that track will be prohibited. If you switch the
COPYRIGHT button to the PERMIT setting, digi-
tal copying of that track will be permitted.
9
Repeat steps 6–8 to select the stereo tracks
that you want to write to track numbers 2
and following of the CD.
Tip!
• If you move the cursor to the NEW button and press
the [ENTER] key, a new track will be added follow-
ing the last track number.
• If you use the INS button instead of the NEW but-
ton, a new track will be inserted before the currently
selected track number.
• If you use the DEL button, the currently selected
track number will be deleted from the list.
When you use the NEW button or INS button to add a
track number, the same stereo track will be always
selected as the initial setting. Be careful that you do
not inadvertently select the same stereo track twice.
10
As necessary, use the WRITE SPEED buttons
in the lower left of the display to specify
the writing speed.
The x1/x2/x4/x6 buttons correspond to single,
2x, 4x, and 6x writing speeds. Normally you
should select the fastest speed that your CD-RW
drive supports.
If errors occur repeatedly during writing, select a
slower writing speed.
11
When you have finished selecting all the
stereo tracks that will be written to the CD,
move the cursor to the EXECUTE button in
the lower right of the display, and press the
[ENTER] key.
A popup window will ask you to confirm execu-
tion of the mastering operation.
Operation section
12
183