Yamaha AW2816 Owner's Manual page 257

E
REC.TR (Recorder Tracks)
This area displays the connection status of tracks
1–16. The (jack) symbol displayed at the left of
this area indicates the recorder input of each track.
If you move the cursor to the jack and press the
[ENTER] key, the track of that row will be high-
lighted, indicating that it is selected for operations.
If you move the cursor to a selected track and
press the [ENTER] key once again, the selection
will be defeated.
F
ALL CLEAR button
This button cancels all patch cables.
G
CLEAR button
This button cancels the patch cable connected to
that track.
H
EXECUTE button
When you move the cursor to this button and
press the [ENTER] key, the patching you specified
in the Quick Rec page will take effect. When you
do this, the input channels/tracks connected by the
patch cables will change as follows.
• The signal flow of the corresponding input chan-
nels and tracks will change according to the
patching you specified in the Quick Rec page.
• Assignments to the stereo bus will be forcibly
turned off for the corresponding input channels.
• On the monitor channels for the corresponding
tracks, the mix parameters will be reset to the
default values.
• All corresponding tracks will be in record-ready
mode.
• If the FLAT button is on, the settings of input
channels to which a patch cable is connected
will be reset to the default settings.
For details on operations in the Quick Rec page,
refer to page 80.
• Input channels/tracks (monitor channels) to which
no patch cables are connected in the Quick Rec page
will not be affected in any way.
• When you access the Quick Rec page, the patch
cables will be displayed according to the settings that
you made most recently. However if you have manu-
ally modified the input patching or recorder input
patching in another screen, the patch cable display
may not necessarily match the actual signal flow.
Reference section
255