Removing And Installing Clutch Release Mechanism - Skoda Fabia II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
8 - Ball pin
❑ for small engaging lever Pos. 7
❑ replace when replacing the double clutch
9 - Screw
❑ Replace after disassembly
❑ 8 Nm + 90°
10 - Guide bushing-bottom part
❑ for small engaging lever Pos. 7
❑ is removed and installed together with the guide bushing-top part Pos. 6
1.2 Removing and installing clutch release
mechanism
⇒ "1.2.1 Removing and installing clutch release mechanism, ver‐
sion up to 05.2011", page 34
⇒ "1.2.2 Removing and installing clutch release mechanism, ver‐
sion as of 06.2011", page 37
1.2.1 Removing and installing clutch release
mechanism, version up to 05.2011
Caution
If the double clutch has to be replaced, the following parts must
always be replaced too:
♦ The two engaging levers with the gear shift bearings
♦ Bearing of the engaging lever
♦ Shims for gear shift bearings
After replacing the double clutch and the corresponding parts,
the position of the gear shift bearings for clutches K1 and K2
will always
⇒ "1.3.1 Adjust clutch release mechanism, gearbox up to
05.2011", page 41
Note
If all the listed parts are only removed and installed, no re-
♦
adjustment is necessary.
The circlip must be replaced under all circumstances.
♦
• Double clutch gearbox removed
⇒ "2.2 Remove double clutch", page 66
• The mechatronics for double clutch gearbox -J743- is installed
on the gearbox
34
Rep. gr.30 - Clutch
require re-adjusting